TP4056 1A lithium battery charging protection board module TYPE C USB

Previous product
BAT-LI-ION-3.7V-2600MAH Original price was: ₹167.00.Current price is: ₹135.00. (Excluding Tax)
Next product
DC DC 4.5 40V To 5V 2A USB Charger Step down Converter Voltmeter Module Original price was: ₹158.00.Current price is: ₹138.00. (Excluding Tax)

Original price was: ₹23.00.Current price is: ₹20.00. (Excluding Tax)

13% Off
Out of Stock
SKU: AI-5311 Category:
Description

TP4056 1A Lithium Battery Charging Module

This TP4056 1A Lithium Battery Charging Module with Current Protection – Mini USB is a tiny module, perfect for charging single cell 3.7V 1 Ah or higher lithium ion (Li-Ion) cells such as 16550s that don’t have their own protection circuit. Based on the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.
Furthermore, when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage – and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.
Manufactured under fully machinery processing. Each module is tested OK before shipment from Robu.in so it has high reliability for the best performance. In conclusion, it is special design for a single lithium battery charging. TP4056 Other features include the current monitor, under-voltage lockout, automatic recharge, and two status pin to indicate charge termination and the presence of an input voltage.
To know more about how to use TP4056 Charging module

Using the module:
-Connect mini USB cable for power, or 5V DC to pads marked IN and IN- on the left-hand side of the module
-Connect cell to charge to B /B- pads on the right-hand side of the moduleA load (something for the battery to power) can be connected to the OUT /OUT- pads on the right-hand side
-Important! Disconnect load when charging
-The red LED indicates charging in progress, a green LED indicates charging has finished.
-Never charge your battery at a rate greater than 1C.

Features:
-Led indicator: red is charging Green is fully charged.
-Current Protection:Yes
-Inversed polarity:NO.
-Use mature charging chip TP4056 for simple peripheral circuits, good protection performance, and high charging accuracy.
-Fully machinery automated processing, all patch parts manufacturing.

Additional information
Dimensions 30 × 17 × 6 cm
Reviews (0)
0 ★
0 Ratings
5 ★
0
4 ★
0
3 ★
0
2 ★
0
1 ★
0

There are no reviews yet.

Be the first to review “TP4056 1A lithium battery charging protection board module TYPE C USB”

Your email address will not be published. Required fields are marked *

Scroll To Top
Close
Close
Shop
0 Cart
Close

My Cart

Shopping cart is empty!

Continue Shopping